CENTRE DE MAINTENANCE
Imprimante & Portable Revenir à la page d'accueilt



4 rue DE BENEDETTI - 13008 MARSEILLE - Tél: 04.91.25.66.32
BGF> Toutes les erreurs matérielles des Imprimantes HP LaserJet.

CODES D'ERREUR HP LaserJet 5L/6L(en Anglais)

Legend for front panel error LED indicators

A common problem with this printer is feeding multiple sheets of paper. We have found the solution to be replacement of the pickup roller assembly and paper separation pad. Cleaning may work for the short term but will not solve this problem. The replacement paper separation pad is an upgraded part which has proven to be a successful fix for this problem. You may find inexpensive fixes but the answer is replace these parts. For the labor involved it's not worth it to scimp on the parts. We have both available along with illustrated instructions.

   A kit with both pickup roller and separation pad kit and illustrated installation instructions is available for $39.00                 BGF Parts Online


Paper Out, door open, no EP cartridge
Paper out, door open or no EP cartridge

Memory Error
 Memory error, too much data or data to complex
Add memory - up to 9 MB or reduce page complexity

  Manual Feed
Manual Feed - waiting for you to add sheet of paper for manual feed from single sheet slot
load paper and then press and release front panel button. Manual feed controlled by software

Sleep Mode
Printer is in sleep mode or unplugged. Press front panel button to wake up printer
Try printing an engine test (sheet of vertical lines) by pressing the engine test button located behind the access hole on the lower front of the printer.

Service Error
Printer service error - no further operation possible until problem resolved. Press front panel button to see secondary indicator pattern. See information on secondary patterns below.

Fuser Error
This LED pattern, shown while pressing the front panel button, indicates a fuser error. Measure the resistance between pins one and two of connector J102 - they should read 30 +/- 10 ohms. If open, the fuser ceramic heating element will need to be replaced.

Scanner Error
This LED pattern, while pressing the front panel button, indicates a laser scanner error. Power cycle the printer by unplugging from the power source. If error persists, scanner may need replacement. In rare instances a defective DC controller may cause this error.

Formatter Error
This LED pattern, while pressing the front panel button, indicates a formatter error. Power cycle the printer by unplugging from the power source. If error persists, remove printer data cable and power cycle again. If error persists you will need to replace the formatter PCA.
Tous droits réservés BGF® Informatique

Copyright © 2008 BGF™ - Tous droits réservés -
BGF est une marque déposée par BGF Informatique